Fire-Lite W-DIS-D SWIFT Wireless Display Driver

Description

FireLite® Alarms’ SWIFT® (Smart Wireless Integrated Fire Technology) Wireless System can be applied in many situations that are problematic for traditional wired devices. In cases where areas of a building are difficult or impossible to wire, visually sensitive, or have restricted access, SWIFT wireless sensors provide an efficient, reliable solution.

SWIFT wireless devices communicate via a proprietary wireless mesh protocol to communicate with FireLite fire alarm systems by means of a SWIFT wireless gateway. The SWIFT gateway connects to the SLC loop of an ES-200X, ES-50X, MS-9200UDLS or MS9600(UD)LS panel using LiteSpeed™ protocol. New type IDs for wireless devices are supported (for the ES-200X and ES-50X only) that allow the FACP to display all events such as alarms and trouble indications, as well as unique trouble conditions required for wireless devices. This capability eliminates the need for a supplementary annunciator for wireless event messages.

Wireless devices in a SWIFT network develop “parent-child” communication links with other devices in the mesh, so that a message originating from a remote device “hops” to the closest parent device, and then to successive parent devices until the message reaches gateway. Alternate paths are also identified and supervised by the SWIFT protocol providing approved Class A wireless communication. If a device does not have an established communication path with adequate signal strength, an additional device such as a wireless module may be installed in between so that it will act as a repeater.

Features:

• Wireless mesh technology (902-928 MHz frequency)
• Cascading-wave mesh operation provides a verification of redundant communication paths
• Any wireless device can be added to act as a repeater
• Each gateway supports up to 50 addresses: 1 wireless gateway, 1 display driver, if required, and up to 49 devices
• Up to 4 wireless networks can be installed with overlapping radio network coverage