Showing 49–64 of 362 results
$ 80.49In stock
Red and green LEDs to simplify local status indication during power-up, standby, alarm, maintenance, and freeze trouble conditions
Installer-friendly base and plug-in design
Form C relay
$ 68.14In stock
Provides wide-angle red and green LED indicators for instant inspection of the detector’s condition
Plug-in detector line, mounting base included
135°F fixed thermal sensor.
$ 44.28In stock
The 5600 series offers a full-line of configurations to acco mmodate a broad range of applications.
$ 119.59In stock
The best-in-class i4 Series combination CO/Smoke detector is a 2-Wire carbon monoxide (CO) and smoke detection technology in a single, system-connected device.
$ 126.49In stock
4-wire module is compatible with COSMO-4W combination detectors and 4WTA-B smoke detectors
Easily integrates up to 12 compatible detectors to a wide range of control panels
Sends distinct smoke and CO signals from i4 detectors to the panel
$ 94.75In stock
Listed to Underwriters Laboratories 268A specifically for use in no-flow/low-flow air-handling systems.
Accepts 24 or 120V supply voltage
Two LEDs blink in standby
$ 56.18In stock
Plug-in detector line, mounting base included
Large wire entry port
In-line terminals with SEMS screws
$ 75.04In stock
Plug-in design (base included)
Isolated thermal sensor
Provides wide-angle red and green LED indicators for instant inspection of the detector”s condition
$ 29.04In stock
The 5600 series offers a full-line of configurations to accommodate a broad range of applications
To satisfy a variety of installation needs, the 5600 series easily mounts to single-gang and octagonal back boxes
The 5600 series provides clear markings on the exterior of the unit to ensure that the proper detector is being used.
$ 32.15In stock
The 5600 series offers a full-line of configurations to accommodate a broad range of applications.
To satisfy a variety of installation needs, the 5600 series easily mounts to single-gang and octagonal back boxes
The 5600 series provides clear markings on the exterior of the unit to ensure that the proper detector is being used.
$ 33.02In stock
The 5600 series offers a full-line of configurations to accommodate a broad range of applications.
To satisfy a variety of installation needs, the 5600 series easily mounts to single-gang and octagonal back boxes
The 5600 series provides clear markings on the exterior of the unit to ensure that the proper detector is being used.
$ 64.39In stock
System Sensor 2WT-B is a 2-wire, photoelectric i3 smoke detector with a 135°F fixed thermal sensor.
$ 69.29In stock
520 Hz ± 10% square wave tone, NFPA compliance
Nominal Voltage Low Frequency Sounder Regulated 24 DC/FWR1
Rotary switch for High/Low, Temp3, Temp4, and Continuous settings. Coded setting.
$ 33.10In stock
Offers high and low volume settings, and temporal or non-temporal tones
Can be mounted to single gang back boxes for aesthetically sensitive applications
Operates between 32 and 120 degrees Fahrenheit from a regulated DC or full-wave rectified, unfiltered power supply
$ 96.89In stock
Weatherproof per NEMA 4X, IP56
Compatible with System Sensor synchronization protocol and legacy SpectrAlert products
Plug-in design with minimal intrusion into the back box
$ 62.15In stock
Is compatible with 2- and 4-wire i3 detectors equipped with a sounder
Allows i3 detector silencing from the panel or keypad
Is usable with bell/alarm, alarm relay, or NAC outputs
