Silent Knight SK-PS6 6 Amp 120VAC Remote Charger Power Supply W/Metal Enclosure

Description

The PS Series is a remote power supply line from Silent Knight and is a direct replacement for the 5495/5499. The SK-PS6 is a 6 amp while the SK-PS10 is a 10 amp, remote power supply with battery charger that may be connected to any 12 or 24 volt fire alarm control panel (FACP) or used as a standalone power supply.

This Series provides 24 VDC power for NACs (notification appliance circuits) configured as either Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options. It also provides auxiliary power, constant or resettable, suited for detectors, annunciators, door holders, and other fire alarm system peripherals.

The PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH batteries in a separate cabinet

Remote Power Supply Features

• Up to five (6 amp model) or seven (10 amp model) independently configurable, power limited output circuits for:
  • Class B and/or Class A NACs
  • Class B and/or Class A resettable or non-resettable 24V auxiliary power -door holder power
• Converts from Class B to Class A wiring without losing any outputs using the ZNACPS converter card (sold separately)
• Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power
• Optional addressable control, monitor, and relay modules and power-supervision relay (EOLR-1)
• Configurable for ANSI® Temporal 3 or Temporal 4 coded output
• UL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances
• Synchronization can be triggered from FACP NAC/remote sync outputs, cascaded power supply, or a control module, single or multi, which may be housed within the power supply cabinet
• Ability to cascade up to four power supplies
• Two (6 amp model) or three (10 amp model) fully-isolated input/control circuits which can be programmed to any output
• Two Form C normally-closed trouble relays for AC Trouble and General Trouble
• 6 or 10 amp full load output, respectively, with 3 A maximum/circuit
• Individual NAC power and trouble LEDs for diagnostic efficiency
• Trouble history mode for diagnostic support
• Wide range end-of-line supervision value (normal: 2-27K ohms)
• Selectable earth fault detection (enable or disable)
• AC trouble report delay timer